Synology CS-406 information

/proc/cpuinfo

 #cat /proc/cpuinfo
  processor       : 0
  cpu             : 82xx
  revision        : 1.4 (pvr 8081 1014)
  bogomips        : 266.24
  chipset         : 8245
  vendor          : Synology Inc.
  machine         : DS-101g+

This realy is from a CS-406 but /proc/cpuinfo shows a DS-101g+

uname -a

 #uname -a
  Linux Alpha 2.6.15 #382 Sun Aug 6 21:48:02 CST 2006 ppc unknown

lsmod

 #lsmod
  Module                  Size  Used by    Tainted: P
  usbhid                 40868  0
  usblp                  10496  0
  usb_storage            29220  0
  uhci_hcd               37168  0
  ohci_hcd               16036  0
  ehci_hcd               27112  0
  ds406_synobios          7864  0
  sk98lin               205132  1
  quota_v2                9408  2
  usbcore               109500  7 usbhid,usblp,usb_storage,uhci_hcd,ohci_hcd,ehci_hcd
  sg                     29892  0
  vfat                   10208  0
  fat                    47740  1 vfat
  appletalk              29212  20
  psnap                   2180  1 appletalk
  llc                     4764  1 psnap

dmesg

 #dmesg
  drive cache: write back
  SCSI device sdb: 625142448 512-byte hdwr sectors (320073 MB)
  SCSI device sdb: drive cache: write back
   sdb: sdb1 sdb2 sdb3
  sd 1:0:0:0: Attached scsi disk sdb
  drivers/scsi/sd.c (1648) Internal disk with bus id: 2
  SCSI device sdc: 625142448 512-byte hdwr sectors (320073 MB)
  SCSI device sdc: drive cache: write back
  SCSI device sdc: 625142448 512-byte hdwr sectors (320073 MB)
  SCSI device sdc: drive cache: write back
   sdc: sdc1 sdc2 sdc3
  sd 2:0:0:0: Attached scsi disk sdc
  drivers/scsi/sd.c (1648) Internal disk with bus id: 3
  SCSI device sdd: 625142448 512-byte hdwr sectors (320073 MB)
  SCSI device sdd: drive cache: write back
  SCSI device sdd: 625142448 512-byte hdwr sectors (320073 MB)
  SCSI device sdd: drive cache: write back
   sdd: sdd1 sdd2 sdd3
  sd 3:0:0:0: Attached scsi disk sdd
  physmap flash device: 1000000 at ff000000
  CFI: Found no phys_mapped_flash device at location zero
  DS406?-0: Found 1 x16 devices at 0x0 in 8-bit bank
   Amd/Fujitsu Extended Query Table at 0x0040
  DS406?-0: Swapping erase regions for broken CFI table.
  number of CFI chips: 1
  cfi_cmdset_0002: Disabling erase-suspend-program due to code brokenness.
  Searching for RedBoot partition table in DS406?-0 at offset 0x3f0000
  6 RedBoot partitions found on MTD device DS406?-0
  DS406? flash bank 0: Using RedBoot partition definition
  Creating 6 MTD partitions on "DS406?-0":
  0x00300000-0x00340000 : "RedBoot"
  0x00000000-0x00200000 : "zImage"
  0x00200000-0x00300000 : "rd.gz"
  0x00340000-0x00350000 : "vendor"
  Mac0 00:11:32:00:e7:4c
  vender Mac1 checksum error ucSum:0x00 Buf:0x00 Sum:0.
  Vender partition MacNum?:1 retlen:64
  0x00350000-0x00370000 : "RedBoot Config"
  0x003f0000-0x00400000 : "FIS directory"
  md: raid0 personality registered as nr 2
  md: raid1 personality registered as nr 3
  md: raid5 personality registered as nr 4
  raid5: measuring checksumming speed
     8regs     :   477.000 MB/sec
     8regs_prefetch:   388.000 MB/sec
     32regs    :   491.000 MB/sec
     32regs_prefetch:   411.000 MB/sec
  raid5: using function: 32regs (491.000 MB/sec)
  md: md driver 0.90.3 MAX_MD_DEVS=256, MD_SB_DISKS=27
  md: bitmap version 4.39
  NET: Registered protocol family 2
  IP route cache hash table entries: 2048 (order: 1, 8192 bytes)
  TCP established hash table entries: 8192 (order: 3, 32768 bytes)
  TCP bind hash table entries: 8192 (order: 3, 32768 bytes)
  TCP: Hash tables configured (established 8192 bind 8192)
  TCP reno registered
  TCP bic registered
  NET: Registered protocol family 1
  NET: Registered protocol family 17
  md: Autodetecting RAID arrays.
  md: autorun ...
  md: considering sda1 ...
  md:  adding sda1 ...
  md: sda2 has different UUID to sda1
  md: sda3 has different UUID to sda1
  md:  adding sdb1 ...
  md: sdb2 has different UUID to sda1
  md: sdb3 has different UUID to sda1
  md:  adding sdc1 ...
  md: sdc2 has different UUID to sda1
  md: sdc3 has different UUID to sda1
  md:  adding sdd1 ...
  md: sdd2 has different UUID to sda1
  md: sdd3 has different UUID to sda1
  md: created md0
  md: bind<sdd1>
  md: bind<sdc1>
  md: bind<sdb1>
  md: bind<sda1>
  md: running: <sda1><sdb1><sdc1><sdd1>
  raid1: raid set md0 active with 4 out of 4 mirrors
  md: considering sda2 ...
  md:  adding sda2 ...
  md: sda3 has different UUID to sda2
  md:  adding sdb2 ...
  md: sdb3 has different UUID to sda2
  md:  adding sdc2 ...
  md: sdc3 has different UUID to sda2
  md:  adding sdd2 ...
  md: sdd3 has different UUID to sda2
  md: created md1
  md: bind<sdd2>
  md: bind<sdc2>
  md: bind<sdb2>
  md: bind<sda2>
  md: running: <sda2><sdb2><sdc2><sdd2>
  raid1: raid set md1 active with 4 out of 4 mirrors
  md: considering sda3 ...
  md:  adding sda3 ...
  md:  adding sdb3 ...
  md:  adding sdc3 ...
  md:  adding sdd3 ...
  md: created md2
  md: bind<sdd3>
  md: bind<sdc3>
  md: bind<sdb3>
  md: bind<sda3>
  md: running: <sda3><sdb3><sdc3><sdd3>
  raid5: device sda3 operational as raid disk 0
  raid5: device sdb3 operational as raid disk 1
  raid5: device sdc3 operational as raid disk 2
  raid5: device sdd3 operational as raid disk 3
  raid5: allocated 4210kB for md2
  raid5: raid level 5 set md2 active with 4 out of 4 devices, algorithm 2
  RAID5? conf printout:
   --- rd:4 wd:4 fd:0
   disk 0, o:1, dev:sda3
   disk 1, o:1, dev:sdb3
   disk 2, o:1, dev:sdc3
   disk 3, o:1, dev:sdd3
  md: ... autorun DONE.
  RAMDISK: Compressed image found at block 0
  VFS: Mounted root (ext2 filesystem).
  ds406_synobios: module license 'Synology Inc' taints kernel.
  drivers/synobios/ds406-synobios.c(617)target = 32
  I2C? read 0x20
  I2C? read 0x46
  I2C? read 0x7
  I2C? read 0x5
  I2C? read 0x17
  I2C? read 0x11
  I2C? read 0x6
  synobios: load, major number 201
  ====== MODEL_CS406 ======
  synobios: unload
  kjournald starting.  Commit interval 5 seconds
  EXT3? FS on md0, internal journal
  EXT3?-fs: mounted filesystem with ordered data mode.
  kjournald starting.  Commit interval 5 seconds
  EXT3?-fs warning: checktime reached, running e2fsck is recommended
  EXT3? FS on md2, internal journal
  EXT3?-fs: mounted filesystem with ordered data mode.
  kjournald starting.  Commit interval 5 seconds
  EXT3? FS on md0, internal journal
  EXT3?-fs: mounted filesystem with ordered data mode.
  VFS: Mounted root (ext3 filesystem).
  Trying to move old root to /initrd ... okay
  Freeing unused kernel memory: 124k init
  Adding 393464k swap on /dev/md1.  Priority:-1 extents:1 across:393464k
  NET: Registered protocol family 5
  sd 0:0:0:0: Attached scsi generic sg0 type 0
  sd 1:0:0:0: Attached scsi generic sg1 type 0
  sd 2:0:0:0: Attached scsi generic sg2 type 0
  sd 3:0:0:0: Attached scsi generic sg3 type 0
  usbcore: registered new driver usbfs
  usbcore: registered new driver hub
  sk98lin: Network Device Driver v8.31.2.3
  (C)Copyright 1999-2006 Marvell(R).
  eth0: Yukon Gigabit Ethernet 10/100/1000Base-T Adapter
        PrefPort?:A  RlmtMode?:Check Link State
  drivers/synobios/ds406-synobios.c(617)target = 32
  I2C? read 0x27
  I2C? read 0x46
  I2C? read 0x7
  I2C? read 0x5
  I2C? read 0x17
  I2C? read 0x11
  I2C? read 0x6
  synobios: load, major number 201
  ====== MODEL_CS406 ======
  kjournald starting.  Commit interval 5 seconds
  EXT3?-fs warning: checktime reached, running e2fsck is recommended
  EXT3? FS on md2, internal journal
  EXT3?-fs: mounted filesystem with ordered data mode.
  eth0: network connection up using port A
      speed:           1000
      autonegotiation: yes
      duplex mode:     full
      flowctrl:        symmetric
      role:            master
      irq moderation:  disabled
      scatter-gather:  enabled
      tx-checksum:     enabled
      rx-checksum:     enabled
  ehci_hcd 0000:00:0e.2: EHCI Host Controller
  ehci_hcd 0000:00:0e.2: new USB bus registered, assigned bus number 1
  ehci_hcd 0000:00:0e.2: irq 17, io mem 0xbfffcf00
  ehci_hcd 0000:00:0e.2: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004
  hub 1-0:1.0: USB hub found
  hub 1-0:1.0: 5 ports detected
  ohci_hcd: 2005 April 22 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI)
  ohci_hcd 0000:00:0e.0: OHCI Host Controller
  ohci_hcd 0000:00:0e.0: new USB bus registered, assigned bus number 2
  ohci_hcd 0000:00:0e.0: irq 17, io mem 0xbfffe000
  hub 2-0:1.0: USB hub found
  hub 2-0:1.0: 3 ports detected
  ohci_hcd 0000:00:0e.1: OHCI Host Controller
  ohci_hcd 0000:00:0e.1: new USB bus registered, assigned bus number 3
  ohci_hcd 0000:00:0e.1: irq 17, io mem 0xbfffd000
  hub 3-0:1.0: USB hub found
  hub 3-0:1.0: 2 ports detected
  USB Universal Host Controller Interface driver v2.3
  Initializing USB Mass Storage driver...
  usbcore: registered new driver usb-storage
  USB Mass Storage support registered.
  usbcore: registered new driver usblp
  drivers/usb/class/usblp.c: v0.13: USB Printer Device Class driver
  usbcore: registered new driver hiddev
  usbcore: registered new driver usbhid
  drivers/usb/input/hid-core.c: v2.6:USB HID core driver

This dmesg does not look complete. Somehow the first part is missing.

cat /proc/mtd

 #cat /proc/mtd
  dev:    size   erasesize  name
  mtd0: 00040000 00010000 "RedBoot"
  mtd1: 00200000 00010000 "zImage"
  mtd2: 00100000 00010000 "rd.gz"
  mtd3: 00010000 00010000 "vendor"
  mtd4: 00020000 00010000 "RedBoot Config"
  mtd5: 00010000 00002000 "FIS directory"